ICEBreaker 1.0E FPGA Lattice ICE40UP5K Development Board RISC-V Open Source Core Board Supports Nextpnr Yosys Two internal oscillators (10 kHz and 48 MHz) for simple designs.Eight DSP multiplier blocks for signal processing such as audio synthesis and even software defined radio Low power consumption perfect for battery-powered applications.Three 24 mA drive and 3 x hard IP PWM (can drive RGB LEDs and small motors) Plentiful, fast storage 128 Mbit (16 MB) quad SPI double data rate (QSPI-DDR) flash.Example: can stream video to LED matrix Lots of I/O Features & Specifications Lattice iCE40UP5k FPGA 5280 logic cells (4-LUT + Carry + FF) 120 Kbit dual-port block RAM 1 Mbit (128 KByte) single-port RAM PLL, 2 x SPI, 2 x I2C hard IPs Three pins (header) for RGB LED Two on-board LEDs One UART, RX pin and TX pin accessible via virtual (USB) serial port One pushbutton Two available Pmod connectors (16 x pins total) One breakaway Pmod (8 x pins) Pre-wired, breakaway Pmod module Input and output user accessible and usable in your own hardware design Five LEDs in a star pattern Three push buttons Capable enough to host CPU softcores picorv32 picosoc RISC-V and others On-board FPGA programmer and USB-to-serial adapter Compatible with IceStorm iceprog tool Easy, driverless connection as a serial device to host computer USB high speed On-board FT2232 USB chip Up to 480 Mbit/s interface to host computer Pmod Connectors & Breakaway Pmod The iCEBreaker FPGA board has three standard Pmod connectors, which makes for a wide range of expansion options since Pmod is a standard followed by several hardware manufacturers. This gives you access to a massive library of modules - no matter what your project, you're sure to find a Pmod for it. colour:blue Material:PCB size:8*4cm Package Contents: 1 x Digital Development Board Only the above package content, other products are not included. Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.