10pcs Transparent Sticker Images Silicone Resin Mold Epoxy Acetate Holographic Features: Each Pack contains 10 Images. Peel of backing and attach to a clear coat of resin. Cut out desired images and add into your resin protects, to keep the image in the desired place cure a layer of resin first, then add image into another thin layer, wait for this to cure before filling the rest of the mold. This way the image wont float or sink to the bottom. Once resin added around the image you will not be able to see the edges of the image where it was cut. To make sure no bubbles are left on the image you can brush some resin onto it before added to the project or run a tool along the image to remove any trapped bubbles from underneath.