Feature: 1. Multi Purpose: Stainless steel jet pump can be used for water, high floor, solar, water heater, bathroom, water tower water supply booster, etc. 2. High Speed: 1100W stainless steel jet pump is full of power, 2860 revolutions per minute, the maximum stream is 5.0 tons per hour, and the water is fast and large. 3. Stainless Steel: Jet pump is made of 304 stainless steel, which is rust free, corrosion resistant, safe and healthy, and can be used with confidence. 4. Good Heat Dissipation: 1100W stainless steel jet pump adopts heat dissipation wind wheel, which can dissipate heat efficiently, make the motor work for a long time and improve efficiency. 5. Fixed Base: Garden pump has a high hardness bottom, and the design installation holes are convenient for the pump to be fixed on the ground and wall, which is safe and firm. Specification: Item Type: 1100W Stainless Steel Jet Pump Material: Stainless Steel Product Size:Approx. 41 x 19 x 21cm / 16.1 x 7.5 x 8.3in Rated Voltage: 220V 50HZ Maximum Stream: 5.0m³/h Rated Stream: 4.0m³/h Speed: 2860r/min Power: 1100W Suction Lift: 9m Maximum Lift: 50m Rated Lift: 40m Caliber: DN25/1 Inch Weight: Approx. 10700g / 377.4oz . Package List: 1 x 1100W Stainless Steel Jet Pump1 x Foot Valve2 x Stainless Steel Adapter1 x Tape1 x Check Valve1 x User Manual Note: 1. The grounding wire must be grounded before use to prevent electric shock when the insulation is poor. For safety, be careful not to wet the power plug.2. Before grounding the wire, turn off the power. Never connect the ground wire to the gas pipe, otherwise there is a danger of explosion.3. Avoid running the pump without water, which will shorten the life of the pump, and the motor will heat up and be prone to failure.4. Do not use any liquid other than water. When using soluble substances such as benzoic acid, flammable substances such as gasoline and high‑viscosity liquids, it is easy to cause fire.5. In cold weather, when using the water pump, do not wrap the hydrogen motor or pump head with a quilt or cloth to prevent freezing, because the motor heats up and there is a danger of fire.6. Do not expose the pump to direct light to work, which will affect the service life of the pump.7. The water pump should be used as a towel during the suction process. After the palm of your hand is blocked, do not move around. It is best to fill the pump body! This test suction step can be tried several times to ensure that the pump does not suck air in.