1.3 strings of 12.6V 40A lithium battery protection board (with its own recovery function - AUTO Recovery);2. Integrate 10 imported low-resistance MOS tubes, with a continuous discharge of 40A, suitable for electric drills, sprayers, LED lights, and low-power inverters;3. Scope of application: Applicable to 4.2V lithium battery with nominal voltage of 3.7V and full voltage (including 18650/26650, polymer battery, no limitation on size)4. It is suitable for electric drills with starting current below 80A and power below 170W.5. The high current heating is reduced by 30%, and the anti-interference function is increasedConditions for successfully starting the electric brick:1, 4 15C-20C power batteries or 810C-15C power batteries (ordinary 18650 power drills are required 2. The connection line between the battery pack and the protection board should be as short as possible and as thick as possible;3. When welding the battery for the first time, do not need any load or any equipment at the output end.4. If it still can't start, please contact the shop king again to tell you the solution.Precautions:1: The power drill needs 3 10C-20C power batteries, or 6 5C-10C power batteries (recommended power battery models: VTC4, VTC4A, VTC5A,) 0V and 12.6V connecting wires, use 3 square millimeters Copper wire above (can't use nickel sheet )2: Strictly connect 0V, 4.2V, 8.4V, 12.6V, 16.8V according to the diagram, do not touch any components on the board when soldering the wires, and do not intentionally short-circuit.3: When the battery is welded for the first time or is being charged, as long as a single battery exceeds 4.2V/430 resistance, it will heat up and discharge (discharge to about 4.19V and stop heating). If the 430 resistor is seriously hot (don't dare to touch it when it is too hot), please check whether the wiring is wrongProduct weight: 8.8gColour:greenMaterial:PCBSize: 45 x 55 x 3.4mmPackage Contents:1 x 3 string increase boardOnly the above package content, other products are not included.Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.