125Pcs Furniture Hardware Screw PreInserted Nut Eccentric Wheel 3in1 Connecting Kit Tools Item Type: Furniture Hardware ScrewMaterial: Stainless steelSpecification:10 x Dowel: Approx. 6 x 40mm / 0.2 x 1.6in 10 x Dowel: Approx. 6 x 35mm / 0.2 x 1.4in 10 x Dowel: Approx. 6 x 32mm / 0.2 x 1.3in 30 x Eccentric Wheel: Approx. 11.6 x 14.9mm / 0.5 x 0.6in 5 x Flat Head Hex Bolts: Approx. 6 x 70mm / 0.2 x 2.8in 5 x Flat Head Hex Bolts: Approx. 6 x 50mm / 0.2 x 2in 5 x Flat Head Hex Bolts: Approx. 6 x 30mm / 0.2 x 1.2in 30 x Pre-Inserted Nuts: Approx. 6 x 10.5mm / 0.2 x 0.4in 10 x Barrel Nuts: Approx. 6 x 15mm / 0.2 x 0.6in 10 x Barrel Nuts: Approx. 6 x 12mm / 0.2 x 0.5in Installation Instructions:Step 1: Knock the rubber particles into the "target position", the first board has been knockedStep 2: Tighten the screw and attached to the particles,Step 3: Align the hole of the board 2 with the screw and place it on board 1, while aligning the positioning dowelFinally tighten the eccentric wheel clockwise and tighten the screwInstallation Method:1. First install the three-in-one component in the above picture with a screwdriver into the reserved plastic hole 2. As shown in the figure after completing the first step3. Use a hammer to install the cork into the corresponding empty space of the other plate4. Connect the 2 plates to be combined according to the above picture5. Use a screwdriver to install the three-in-one component into the hole as shown in the figure above and tighten it6.ОК