Feature: 1. Wide Application: The bilge water pump is applicable for boats, yachts, fishing boats, etc. can be used as water pumps, bilge pumps, drainage pumps. 2. High Flow: This bilge pump has a large flow rate, low power consumption and high lift, which can be used for large ships to pump seawater. 3. Parameter: The rated voltage is 12V, the power is 120W, the current is 10A, with 15A fuse, 3.3m of wire length, 7000 rpm speed, with high performance. 4. High Conductivity: The bilge pump housing is made of plastic, built in all copper motor which has excellent electrical conductivity, ensure high work efficiency. 5. Easy to Install: Stringently manufactured to meet the original standard, perfect replacement for the old or broken one, improving the time efficiency. Specification: Item Type: Bilge Water PumpMaterial: Plastic, copper motor .Rated Voltage: 12V Power: 120W Current: 10A Fuse: 15A Head: Approx. 8.5m/27.89ft Caliber: Approx. 25mm/0.98in Wire Length: Approx. 3.3m/10.83ft Speed: 7000 rpmWiring: Brown wire connected to positive pole, black wire connected to negative poleApplication: Used for boats, yachts, fishing boats, etc. as water pumps, bilge pumps, drainage pumps Installation: 1. Remove the filter from the bottom of the pump by pressing down on the lock tabs on both sides of the pump. 2. Determine the suitable installation location for the pump 3. Place the filter so that the pump outlet nozzle is in the correct position to connect the outlet hose 4. Install the filter 5. Install the pump on the filter so that the two lock tabs snap into place. 6. Connect the outlet hose to the water spout of the pump (flexible hose is recommended) 7. Install accessories 8. Wiring: To prevent electrolysis and corrosion of wiring, all wire ends and terminals must be located above the highest water level, fixed with insulating nails or cable ties Package List: 1 x Bilge Water Pump1 x Manual Note: When the ship is stationary, the installation must allow the complete emptying of the outlet hose of the bilge pump. The outlet hose must be kept level or continuously up to eliminate all puddles If you are replacing an older bilge pump with a smaller diameter outlet hose, you may need to use an adapter to connect to a larger outlet size on the pump. Restricting the flow of the pump with a smaller hose will not damage the pump, but will reduce the rated flow.