The DC1804T DC1822 DC1414 Ni-cd and Ni-mh battery charger is compatible with Makita 7.2 V, 9.6 V, 12 V, 14.4 V, 18 V nickel batteries. Not suitable for lithium batteries. Specifications: Input: 100V-240V, 30W, 50-60Hz. Output: 7.2V, 9.6V, 12V, 14, 4V, 18V, 1.5A. The durable and powerful charger allows your cordless screwdriver and cordless drill to charge quickly, so your power tool is always ready to go The built-in charger diagnostic program checks the battery every time it is charged, and the LED indicator clearly shows whether the battery is fully charged or defective. Intelligent protection against battery overload or short circuit. The cooling system helps stable heat dissipation when charging. to extend the service life Product Information Ni-Mh/Ni-cd charger is widely compatible with Makita PA14 1420 1422 1433 1434 1435F JR140D 192699-A 1220 PA12 1222 1233S 1233SA 1233SB 1235 1235A 1235B 192598-2 5026DA 4334D 6281D 6281DWE 6227DWE 1050DWD 4331DWD 5093DWD 6835DWD 1050DWD 4331DWD 5093DWD 6010D 6261D 6226DWE 6270D 6270DWE 6271D 6271DWE 6280D 6280DWE Specification:Input:100V- 240V 30W 50-60HZ Output: 7.2V, 9.6V, 12V, 14.4V, 18V, Current: 1.5A Suitable for Ni-cd/Ni- batteries Mh (battery not included) Replacement charger of DC1804T DC1822 DC1414 LED indicator instructions: red light on --- charging green light on --- full charge red and green flashing --- battery fault red flash --- -Short circuit Size: 8 x 6 x 15.5 cm Quantity delivered: 1 piece