x Tile Leveling System (302Pcs)Material: PP + 430 Stainlss SteelSuitable Spacer: 2mm-6mm SpacerTile Thickness: 5mm -20mmColor: As the picture showsFeatures: Wear-resistant, reusable. Easy to use for DIY. Keep tiles balance on the same horizontal position. Improve tile installation speed. Reduce installer fatigue/stress. Virtually no-slip flat surface. Reduces the need for grinding and polishing. Prevents tiles from moving while drying.How to use:1.Before paving the first tile, leave more than 2mm (use with cross spacer).Close to the tiles.2.Insert a T-shaped needle along the gap in the tile.3.Then rotate 180 degrees, T-shaped needle stuck at the bottom of the two tiles.4.Adjust the stoppers with your hand / special wrench until the two tiles are at the same level.5.About 4-6 hours after leveling, before the cement / adhesive is completely dry, rotate the stoppers in the opposite direction, pull out the T-shaped needle 180 to the word, pull out.Notes:1.Due to manual measurement, please allow 1-3cm error, thank you.2.Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. The item may be slightly different from the color shown in the pictures. Thank you!,"