Product Parameters Product Name: DIY Soft Clay Heat Gun Plug Type: EU Plug Product Voltage: 220V Product Power: 300W Temperature Range: > 200C Outlet diameter: 12mm Product packaging: color box Product weight: 213g (net weight), 275g (with packaging) Product application: soft ceramics, DIY stamp convex powder, embossing powder, shrink wrap Power Source Type AC Power Notes 1 Do not use a heat gun, to blow directly on the object at a 90 angle. 2. The recommended distance between the air outlet of the heat gun and the heated object is 5-6cm. 3. Single use of the heat gun should not take too long, usually 2-3 minutes. It is as if the body temperature had obviously increased. Please turn off the heat gun and wait for it to cool down before using. 4. The temperature of the heat gun can only reach about 200, and it is impossible to desolder small pieces of iron Fire, electric shock and injury, you should follow the basic safety precautions listed below; Please read the following safety instructions carefully before proceeding. 1. Keep work area clean and do not use power tools in cluttered work areas and work surfaces. 2. Do not use power tools in dark, damp places. Keep it away from the rain. Do not use in flammable liquids or in areas where flammable gases are present. 3. Keep children and idlers away from the workplace. The rollers must not come near tools or electric cables. 4. When the power tool is not in use, it should be stored in a dry place, out of the reach of children and locked up. 5. Maintain proper feeding speed and pressing speed to make tool operation safer and longer lasting. 6. Work within specified scope and do not exceed compliance for overload management purposes. 7. You must have correct posture at work, you must have firm footing, and you must not stretch your hands over tools to pick things up. 8. Knives should be lubricated and replaced from time to time to stay sharp and the threads should be checked regularly. 9. Be sure to unplug the power cord when tools are not in use or for maintenance when changing tools and knives. 10. Check before turning on the switch to operate the machine. Check that the cutting edge adjustment tools and the attachment key are completely removed. 11. To prevent accidental starting, you must ensure that the tool switch is off before inserting the plug into the power source. After turning on, do not press the switch frequently with your finger. 12. Outdoor extension cord: When using outdoor tools, be sure to use outdoor extension cords. 13. Do not wear loose clothing or accessories to avoid entanglement while the tool is rotating. Rubber gloves and non-slip work shoes should be worn outdoors. Protective cap. 14. Use safety glasses and wear a mask if there are too many chips and dust. 15. Do not step on the wire, pull the wire moving tool, or touch hot objects and sharp metal edges or wet grease. 16. Fix the part. Use pliers to secure the piece to be cut, which is safer than holding the piece with your hand. 17. When repairing or replacing parts, be sure to use genuine factory specified parts and send them to a professional repair center for replacement. 18. Pay attention to the part and the tool together. Tools should not be used when fatigued. 19. Before using the tool, you should carefully check whether the tool cover or other parts are damaged, and check whether the degree of damage will affect the normal operation of the tool. Check if all moving parts are in the correct position, if the parts to be fixed are fixed, etc. If the cover or other parts are damaged, if there is a problem with the switch of the tool, please contact a specialized store to have it repaired or replaced. Do not force a malfunctioning switch to activate the tool. 20. During work, your body should not come into contact with grounded metal objects such as iron pipes, radiators, refrigerators, etc. Please allow slight deviations in the measurement data and make sure you don't mind before ordering. High quality shop for you