Notes: 1. The fan must blow air down across the flns.Be sure the "V" decal faces up.2. The fan plug should face the front of the VXL-3S3. The fan is not water resistant.4. Always turn off the VXL-3S and unplug the model battery when not in use5. Periodically removethe fan and clean and debris from the fan and the heat sinkInstallation:1.To install the cooling fan,press the fan tabs over the VXL-3S heat sink until they snap on.2.Plug the VXL-3S cooling fan connector into the plug on the front of the cooling fan.Suit For:Hoss VXL4-Tec 2.0 VXL AWD ChassisBandit VXLDrag Slash Fiesta ST Rally VXL VXLSlash PlatinumSlash UltimateSlash VXLSlash Slash VXLStampede VXLStampede VXLTool Supplies:Assembly CategoryUpgrade Parts/Accessories:Cooling FanRC Parts & Accs: AccessoriesUse:Vehicles & Remote Control ToysTechnical parameters:Value 2Remote Control Peripherals/Devices:ReceiversFor Vehicle Type:CarsFour-wheel Drive Attributes:AssemblageWheelbase:Screwscolor:BlueMaterial:plasticPackage Contents:2 x Cooling FanOnly the above package content, other products are not included.Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.