説明
  1. The noise of the switch is small and will not have too much impact on the speaker. It is recommended to add a horn protection circuit. The horn protection circuit can not only eliminate the impact noise of the power amplifier switch machine, but also avoid the output DC burning the horn when the power amplifier is damaged.
2. The bottom noise is small. Zero floating small, do not need to do any debugging after installation, the output zero drift voltage will generally not exceed 50mv, and is relatively stable.
3. Free debugging. As long as the connection is correct, no one is wrong, basically it is a success, no need to do any debugging, beginners also have a very high success rate.
Operating voltage: Dual DC 10-45V recommended Dual DC 35V
Rated output power: 100W(4 Ohm  35V)
Maximum output power: 150W (4 Ohm  45V) enormous heat, is not recommended
PCB size: 80 x 50 x 35mm
Pitch: 5.08mm
Hole distance between two power tube: 47mm
Note:due to different production batches, the appearance is slightly different, which does not affect the use.
Colour:As Shown
Material:plastic+metal
Package Contents:
1 * power amplifier board
Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.
  
  
  
      - 
          Fruugo ID: 
          409959872-868091592
      
 
  製品安全情報
  以下に概説するこの製品に固有の製品安全性情報を参照してください。
  以下の情報は、この製品を販売する独立したサードパーティ小売業者によって提供されています。
  
    
      
        
          製品安全ラベル
           
        
        
      
    
      
        
        
          
            安全上の警告: 
            
                When using the product, monitor children in real time to ensure safety during use.