Motion detector for indoor use and surface mounting, mounting dimensions Ø115x23.1mm.The range of the motion detector is approximately 6m and 360° (in an open area).The operating time can be continuously adjusted from 10s to 15min.The switching sensitivity of this device can be adjusted depending on the ambient brightness (between 3 and 2000 LUX). The motion detector has a maximum power of 2000W for incandescent bulbs and 1000W for LED bulbs or other energy-saving bulbs.Included in delivery: 2 x Infrared motion detector.Infrared motion detector for indoor ceiling mountingDetection range up to 6m, 360° detection angleThis motion detector offers you various actuation options: Manual switching on and off or switching on in the event of movement and switching off after a specified time.After a preset time of between approximately 10 seconds and 15 minutes, the motion detector switches off again. Using a regulator, it is also possible to adjust the trigger sensitivity of the device depending on the ambient brightness (between 3-2000 lux in the covered area).Maximum consumption: 2000W for incandescent lamps / 1000W for LED lamps or other energy-saving bulbsHousing material: PlasticProtection class: IP20IR sensor adjustment optionsIndoor motion detector, ceiling-mounted, programmable, infrared sensor, LEDIndoor recessed motion detector, suitable for wall mounting, IR sensor, range 9m/160°Detection rangeThe infrared sensor detects movement in an area of up to 6m with a coverage angle of 360° and switches on the lighting device.Duty CycleHow long should your lighting devices stay on?The duration of the duty cycle can also be set, either continuously or according to set time delays. As soon as the sensor detects new movement, the duty cycle starts again.Ambient BrightnessShould your lights only turn on at night?No problem, you can decide whether the sensor triggers your lighting during the day or at night. The sensor can either be set continuously depending on the ambient brightness, or during the day or night.