360HTD Ultrasonic Cleaning Machine Digital Timing Heating Cleaner Equipment 6.5L for Multiple PurposesEU Plug 200~240V Item Type:Ultrasonic Cleaner Model: 360HTD Type: Digital Timing Heating Inner Tank Capacity: 6.5L Inner Groove Size: 300 x 155 x 150mm / 11.81 x 6.1 x 5.91in Ultrasonic Frequency: 40KHz Ultrasonic Power: 180W Heating Power: 300W Number of Vibration Heads: 3 Working Time Range: 1-99Min Temperature Range: 0-80 ° C Liner Material: SUS304 Stainless Steel Shell Material: Stainless Steel Basket: Equipped Sound Reduction Cover: Equipped Function:Glasses, rings, coins, jewelry, industrial parts, hardware tools, watches, dentures, surgical instruments, PCB boards Instruction: 1. After unpacking, shake the machine slightly and listen to the sound in the chassis to confirm whether the parts are loose. 2. Place the machine in a ventilated and dry place to ensure that the machine is in a horizontal position; 3. Add an appropriate amount of cleaning solution (2/3 groove depth <L<3/4 groove depth) as required for cleaning; 5, adjust the ultrasonic working time: After the power is turned on, the right digital screen displays “0700” to indicate that the default setting time is 7 minutes and 00 seconds. Each time the “TIME+” or “TIME-” button is pressed, the time is increased or decreased by 1 minute. After the button is set, press the “ON/OFF” button, the ultrasonic starts to work, and the digital timer counts down. The time setting of this unit has a memory function. After the set time has elapsed, press “ON/OFF” repeatedly, and the machine will continue to work according to the time set by the previous time. 6. Adjust the working temperature (select heating if necessary; mechanical type without heating): The left digital screen displays “50” and the actual temperature “XX”, indicating that the default setting temperature is 50 ℃. Each time the “TEMP+” or “TMEP-” button is pressed, the temperature is adjusted up or down by 1°C. After the button is set to the operating temperature, press the “ON/OFF” button and the heating part starts to work. (The heating function can be freely switched, which is another feature of this machine) 7. Shut down after completing work: After the cleaning work is completed, if it is not necessary to operate, the heating part should be turned off 1th, and the power supply should be disconnected. After the cleaning liquid is cooled to normal temperature, the cleaning liquid is drained, and the inner tank and outer casing are wiped clean. The used machine should be placed dry. Ventilation to avoid moisture in the control circuit. Q: What is an ultrasonic cleaner? A: Ultrasonic cleaning is based on the cavitation effect caused by high frequency ultrasonic wave vibration signal in the fluid. Microscopic bubbles are formed, and then implode violently causing the cavitation which create an intense scrubbing action on the surface of the item being cleaned. Bubbles are small Through to penetrate microscopic crevices, cleaning them thoroughly and consistently. Q: Which products can I clean this model? A: Many products can be cleaned. Common such as glasses, necklaces, earrings, bracelets, electronics, watches, dentures, printer ink heads, razor heads, nibs, coins, badges, pacifiers, etc. Q: Which builders can be properly added for better cleaning and cleaning during the cleaning process? A: You can add cleaning liquid or detergent, such as: detergent, soapy water, disinfectant, etc., but do not add acidic or alkaline solution to the machine to prevent ABS corrosion damage.