[Exquisite decoration] [Attention Window film has practically no color, but it will become colorful under the light, reflecting the rainbow effect, making the room full of color. The rainbow depends on the location and weather conditions of your facility [Privacy Policy] Window film provides privacy and allows light to enter. Confidentiality is 70%. The closer the film, the worse the privacy, and the further away from the film, the better the privacy. Not recommended for use in the bathroom. [Energy saving and anti-ultraviolet] Warm in winter and cool in summer; thermal insulation: reduces thermal conduction and blocks 90% of ultraviolet rays. Minimize furniture fading caused by the sun. [Easy to use] It is very easy to apply and does not require spending a lot of time with water and a small scraper or card. credit. More water, better results. No residue after removal, the membrane can even be reused [Glue-free] Electrostatic glue-free window film reduces the release of chemicals and makes the glass surface smooth without streaks or scratches. Tools: tape, knives, rulers, sprayers and soapy water. 1. Remove the film backing to prevent the window film from falling out. 2. Measure the window film, use a cutter to cut the film, try to avoid sharp objects scratching the surface of the window film, leaving scratches, affecting the appearance. 3. After thoroughly cleaning the window with a cotton cloth, make sure the surface is very clean. 4. Remember to use tape to separate the electrostatic window film from its clear protective layer and install it, otherwise the window film will not stick to the glass. Tip: Stick tape on each side, then peel off the tape. (You can use the small labels we have available to tear off the protective film, or you can use adhesive tape to make small labels yourself). (Key points) 5. Lay the shading film flat on a clean floor with the sticky side up. Spray the window film and the glass with plenty of water (preferably soapy water). (key point) 6. Place the privacy window film on the glass as precisely as possible. 7. After placing, use a scraper to scrape as many bubbles as possible from the center to the edge, then wipe while rubbing. 8. Then use a cutter to cut the excess part at the edge of the window. Delivery quantity: 2 * window film