COMPREHENSIVE VEHICLE COVERAGE Installation Process 1. Remove the tire Remove the valve cap and core and deflate the tire. 2. Remove the tire Attach the tire to the tire changer and align the valve at 1 oclock relative to the tire separation. Insert the tire tool and lift the tire bead on the mount to remove . 3. Remove the sensor Remove the retaining screw and sensor from the valve stem with a screwdriver, then loosen the nut and remove the valve. 4. Install the sensor and valve Slide the valve stem through the valve hole in the rim. Tighten the screw nut to 4.0 Nm using the positioning pin. Install the sensor body against the rim and tighten the screw. 5. Install the tire Place the tire on the rim and ensure that the valve is separated at an angle of 180 degrees. Install the tire over the rim. No sensor programming required The tire pressure sensor is 100 new and comes preprogrammed specifically for your vehicle makemodelyear, you will need to activate them with a scale tool or relearn. Simplified relearn AUTO Relearn TPMS installation is recommended to be performed by trained personnel only. Part Number 15122618 Fit Car For from 200311 to 201403 For from 200311 to 201312 For H3 from 200505 to 201107 For H3T from 200806 to 201007 For ISeries from 200507 to 200808 For Montana SV6 from 200901 to 200911 Color Black Material ABS Package Contents 4 Tire Pressure Sensor The above package content only, other products are not included. Note Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is 13 cm.