The tile leveling adjuster is made of high quality PP plastic, the T needle is made of 430 stainless steel, fine workmanship, wear resistant and can be reused, can be used for a long time. The leveling system kit is easy to use, suitable for 3mm to 18mm tile thickness, suitable for tile gaps 2mm. The tile levelers are wear-resistant and reusable, and the special wrench is ergonomic and labor-saving to improve the tile installation speed. The system Tile leveling pad can keep tile clearing at the same horizontal position, prevents tile shifting during paving, increases paving speed, and keeps tile joints clean and even. Easy to to use. The tile leveling discs are easy to use and install, and the special wrench provided makes it easy to install and remove the level. The package includes 50 pieces of tile leveling system and 1 special wrench, good choice for floor or wall setting, easy to attach or remove with a wrench. Features: Color: black and orange.< /p> Material: polypropylene + stainless steel Quantity: 50 sets/bag + 1 tool Applicable joint: 2mm to 8mm joint. Tile thickness: 5mm-15mm feature: Wear-resistant and recoverable. Easy to do DIY operation. Keep the balance of tiles in the same horizontal position. Improve the installation speed of tiles. Reduces installer fatigue/stress. Almost no lip slippage, flat finish. Reduces the need for grinding and polishing. p> Prevent tiles from moving during curing. Use suggestions: 1. Lay the first tile leaving more than 2 mm apart (to be used with spacers). near the tiles. 2. Insert a T-pin along the space between tiles. 3. Next, rotate 180 degrees and snap in the T-pin at the bottom of both tiles. 4. Use a hand/special wrench to adjust the cover until both tiles are level. 5. About 5-6 hours after leveling, before the cement/adhesive is completely dry, rotate the cap in the opposite direction and remove the T-pin 180 until the writing is deleted. Quantity delivered: 51 pieces Contents: 50 tile leveling systems 1 special key