PD decoy 5V 9V 12V 15V 20V fully supported, hardware jumper solder joints set the voltage, there is no wrong touch or poor contact or software crashes resulting in voltage errors. DIY by yourself, built into various devices that require 5-20V, set the voltage, compatible with PD power supply, The maximum 20V5A100W support, the specific output power depends on how much the charger supports the corresponding gear. Output pads: 4 pitches of 2.54mm, square negative round positive The output is connected to 20V by default. It is recommended to actually check the output voltage before use. Notice:Your charger and cable must support PD protocol . Product 100% can work 5V 9V 12V 15V 20V. Volume: length 21mm width 11mm thickness 4.3mm Input protocol: PD2.0 or PD3.0 Trigger gear: 5V, 9V, 12V, 15V, 20V Static power consumption: less than 1.5mA in all gears Color: Material:PCB Package Contents: 1 * module Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.