60A 10-55V DC brushed motor speed controller with digital LCD display, slow run/stop timer, and forward/reverse rotation capability.

1. Backlit LCD display shows working time, 0-100% speed percentage, current mode, and forward/reverse status. 2. Multiple limit modes are available, with adjustable soft start and soft stop times. 3. Upper and lower speed limits can be set. 4. Total working time can be set; the motor automatically stops after the set time. 5. Supports independent control of forward and reverse speeds. 6. Manual and automatic modes are selectable; in automatic mode, the motor will automatically reverse direction within a set time. 7. Touch switch toggles forward/reverse status; momentary acceleration and deceleration solves the problem of easy damage to traditional potentiometers. Product Type: DC Motor Speed 窶銀€気ontroller Input Voltage: DC10-55V (Specific voltage must be equal to the motor's rated voltage) Output Voltage: Linear load variation Instantaneous Current: 60A Continuous Current: 竕 Speed 窶銀€気ontrol Method: Current-based speed control Speed 窶銀€気ontrol Technique: Jogging +/- Timing: Manual Boundary Function: Yes Slow Start/Slow Stop: Configurable Digital Speed 窶銀€汽isplay: 0-100% Speed 窶銀€騎ange: 0-100% Control Frequency: 15kHz Connection Method: Barrier Terminal Block Compatible Motors: Brushed Motors Module Dimensions: 148x95x36mm / 5.83x3.74x1.42in Mounting Dimensions: 142x88mm / 5.59x3.46in Mounting Method: Recessed Functions: 0-1-2-3-4-5-6-7-8-9 Function settings are as follows: Manual/Automatic Mode Selection Function 0: 1 is manual mode, 2 is automatic mode, the default is manual mode. Slow Run Time Setting Function 1: 000-100, slow start to speed, adjustable time 0-10 seconds, default 1 second. Slow Run Time Setting Function 2: 000-100, slow stop, adjustable time 0-10 seconds, default 1 second. Minimum Speed 窶銀€記imit Setting Function 3: 000-080, adjustable minimum speed 0-80%, less than the maximum speed setting value, default 0. Maximum Speed 窶銀€記imit Setting Function 4: 000-100, adjustable maximum speed 0-100%, greater than the minimum speed setting value, default 100%. Increase/Decrease Setting Function 5: 001 002 005 010 015 020 025. Each press of the increase/decrease button changes the speed by 1%, 2%, 5%, 10%, 15%, 20%, and 25% respectively. Engine Running Time Setting Function 6: 1 second to 99 hours 59 minutes 59 seconds, with a default value of 99 hours 59 minutes 59 seconds. The following functions 7-8-9 are time settings in automatic mode: Forward Rotation Time Setting Function 7: 0 seconds - 99 hours, default value is 10 seconds Stop Time Setting Function 8: 0 seconds - 99 hours, default value is 10 seconds Reverse Rotation Time Setting Function 9: 0 seconds - 99 hours, default value is 10 seconds Limit Switch Mode Selection Function E: E1: No limit switch, default value is no limit switch E2: After pressing the start button, the motor rotates forward to the first limit switch and stops. Pressing the start button again causes the motor to reverse. E3: After pressing the start button, the motor rotates forward to the first limit switch, then reverses to the second limit switch, and finally stops. E4: After pressing the start button, the motor rotates forward to the first limit switch, then reverses, and the cycle repeats. 1 x Motor Speed 窶銀€気ontroller