8 Channel Network Relay Module Remote Control Relay Device Ethernet to RS485 TCP Relay Module,DIY Programming Module

Users Manual: The output does not have voltage. The single relay has a DC rating of 10A, an AC rated current of 10A, a maximum AC rating of 250V, and a maximum DC rating of 30V. IN9 means full open, after IN9 has digital input, all relays are connected. IN10 means full off. When IN10 has output, all relays are off. The 8-input user of IN1-IN8 can be configured into three different working modes through the configuration parameter tool, and is selected under the "Input Mode" of the configuration tool. In the "normal input" mode, the ordinary input signal is acquired. To obtain the input status, a command to read the input status is sent to the device. "Trigger Relay" mode, after this mode has input, the corresponding relay state is reversed, and the IN1-IN8 control corresponds to the 1-8 relay. The device has an RS485 interface. It can be controlled by RS485 equipment from other manufacturers. Can realize the transparent transmission of network data to RS485 data, the baud rate 300-115200 can be configured. When using parity, the data bit must be configured to 9 bits, and the serial port parameters are configured through the configuration tool. Color: As Shown Material: plastic Package Contents: 1*8 Channel Network Relay Module Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.