説明
For Adblue Emulator Stable Performance High Sensitivity Truck Scanner Emulator for MAN Euro 6
Item Type: Emulator
Material: ABS
Emulators Disable System:
For AdxBlue system (Fully)
For AdxBlue NOX sensor
DPF system
DPF temperature sensors
DPF regeneration
After installing Emulator, you can remove:
DPF sensors – YES
NOx sensor – YES (only in DAF, don’t remove first NOx sensor)
For Adblue Temp, sensor (s) – YES
For Adblue Pump – YES
For Adblue Level sensor – YES
For Adblue ECU – YES
Kindly note: It is possible to disable for AdxBlue system by installing an for AdxBlue emulator (programmable device) into the vehicle. You can switch it on or off anytime.
Emulators using guide:
Emulator for Man Euro 6 does not need to be learned. You install emulator under the metal cover of for AdBlue Pump on the right side behind the cab, and disconnect plug from for AdBlue Pump and connect emulator.
Next, you need to remove the fuses:
F894(Multisensor In for AdBlue tank)
F738 (+30 Signal of for AdBlue pump)
F1084 (NOx sensor Upstream)
Fuse F737 is now fuse of emulator.
Fuse F1109 is the fuse of NOx sensor Downstream and A1191 mufler temperature sensor. This sensor needs to work correctly for DPF regeneration.
Finally you need to remove Power from NOx downstream sensor. There are two ways options, one is to cut pin 1 in NOx sensor plug, the other way (better) is to remove pin 10 in X3212 plug. This plug is visible on rear of engine on the right side. This is TE plug (16 pin) with yellow key.
-
ブランド:
Unbranded
-
カテゴリー:
金属探知機
-
Fruugo ID:
412088651-871534096
-
EAN:
9491334982826