AM5 CPU Bending Correction Frame for AMD Ryzen Processors, Secure Mounting Support

1. This product features four-sided flat pressure design instead of multi-point pressure, enabling precise positioning and avoiding contact with capacitors, which helps ensure secure CPU fixation. 2. The contact surface with the motherboard has a flat bottom design and uses standard insulation protection pads to reduce pressure on the motherboard and minimize signal interference. 3. The aluminum alloy side is elevated to further reduce signal interference on the motherboard side. 4. Anodized sandblasted finish with full aluminum alloy CNC precision construction. Installation instructions: 1. Place the motherboard flat on a surface and open the CPU retention bracket. 2. Use the included L-shaped screwdriver to remove the top bracket and set the lower fastener aside. 3. Insert the CPU into the socket. 4. Place the improved retention clip over the CPU top cover and gently shift until it clicks into position. 5. Tighten the screws in a diagonal sequence, turning each screw half a turn alternately until fully secured to ensure even pressure distribution. Color: Red Material: Aluminum Alloy Package Contents: 1 x L-shaped screwdriver 1 x TF71G retention clip 1 x base plate Note: The package includes only the items listed above. Other accessories shown are not included. Lighting and display settings may cause slight variations in the color shown in images compared to the actual product. Measurement may vary by +/- 1-3 cm due to manual measurement.