1. This product features four-sided flat pressure design instead of multi-point pressure, enabling precise positioning and avoiding contact with capacitors, which helps ensure secure CPU fixation. 2. The contact surface with the motherboard has a flat bottom design and uses standard insulation protection pads to reduce pressure on the motherboard and minimize signal interference. 3. The aluminum alloy sides are raised to further reduce signal interference on the motherboard side. 4. Anodized sandblasted finish with full aluminum alloy CNC precision construction. Installation Instructions: 1. Place the motherboard flat on a work surface and open the CPU retention clip. 2. Use the included screwdriver to remove the top bracket and set the lower fastener aside. 3. Insert the CPU into the socket. 4. Position the improved retention bracket over the CPU top cover and gently slide until it clicks into place. 5. Tighten the screws in a diagonal sequence, turning each screw half a turn at a time until fully secured to ensure even pressure distribution. Color: Red Material: Aluminum Alloy Package Contents: 1 x L-type screwdriver 1 x TF71G retention bracket 1 x base plate Note: The package includes only the items listed above. Other accessories shown are not included. Note: Lighting and display differences may cause slight color variations between the image and the actual product. Measurement may vary by +/- 1-3 cm.