This Non standard passive PoE injector is a simple and convenient equipment for PoE or Non PoE devices via an Ethernet cable. This PoE injector is compatible with IEEE802.3af/at network devices.It does not have auto detection function and directly supply power to devices by force as as you connect , powered device or poe splitter must conform to standard IEEE 802.3af/at, the same time your powered device must support poe pin 4/5(+), 7/8(-) midspan.This POE adapter apply for IEEE802.3af/at standard POE powered devices like , and other IP cameras, or being equipped with IEEE802.3af/802.3at standard poe splitter for non POE devices.color:Blackmaterial: plasticKey features:8 LAN ports, 8 LAN and power portsPower VOIP phones, IP cameras, WiFi access points, and so onSame voltage to all ports, power is shared equally2.1 x 5.5 mm for DC plugLED power lightWorks with any Ethernet switch or routerUses 48 V power adapter to output 48 V power supplyMain Specifications:1) Voltage: DC12V-48V(up to 10A)2) Led: Indicate the working state3) Power pin: 4&5(+), 7&8(-); Data pin: 12364) Lan port: 8ports in RJ45(data in), 8port poe RJ45(data&power out)5) Lan environment: 10/100Mbps Base-, Ethernet cable: /EIA 568 .5 or .5e6) Data in: PC/Hub/Switch/Router, etc.7) Working temp: 0~+40C8) Working humidity: 20 ~90% RH non-condensing9) Storage temp & humidity: -20~+85C, 10~95% RH10) Tip: power voltage should not be over DC48VTips:select according your device power consumption, in order to stable running, the power consumption must be lower than the power supply.POE camera or should use 48V (3-4A) power adapter or switching power supply to supply power to the module, and the POE port output can the device normally.This poe injector should be equipped with a power supply, this package does not include power supply.Package Contents:1 x PoE injectorOnly the above package content, other products are not included.Note: Light reflection and different displays may cause the color of the item in the a little different from the real thing. The measurement allowed error is +/- 1-3cm.