Cordless Robotic Pool Cleaner with Automatic Wall Detection

Cordless Convenience for Effortless Pool Care This cordless robotic pool cleaner takes the hassle out of keeping your swimming pool pristine. Designed for both above-ground and in-ground pools, it operates without the restriction of a hose, moving freely to clean the floor, walls, and waterline with strong suction. Its automatic and waterproof construction means you can simply place it in the water and let it get on with the job, giving you more time to enjoy a clean, inviting pool. Smart Navigation and Automatic Reversing The cleaner is engineered to work independently. When it reaches a pool wall, its automatic reversing function activates, prompting the robot to reverse after four seconds and continue its cleaning route. This intelligent movement ensures thorough coverage without you needing to guide it. Should the unit ever require attention, it will automatically position itself against the wall, making it easy to locate and retrieve. Intelligent Power Management for Longevity The built-in power management system is designed to protect the battery and extend its working life. When the internal battery level runs low, the cleaner will automatically steer itself to the pool wall. At this point, the red power light will flash and the green work light will switch off. If the power falls below a safe level, the unit powers down completely. This self-parking feature prevents deep discharge, which can seriously damage battery health, and ensures the cleaner does not stop in the middle of the pool where it would be difficult to reach. Simple and Reliable Operation Operating the cleaner is straightforward. To start, press and hold the power switch on the underside for two to three seconds. The indicator light, motor, and buzzer will run a quick self-check, confirming the unit is entering its normal working state. To switch it off, simply press and hold the same button again for two to three seconds. This simple control system makes daily use hassle-free. Optimised Water Delay for Stable Diving The cleaner features a thoughtful water delay function. After being placed in the water, it waits for 30 seconds before the motor starts. This allows the robot to sink smoothly and land steadily on the pool floor without rolling over during descent. This not only maximises the machine's cleaning effectiveness but also helps prevent the filtration system from becoming completely blocked, ensuring the robot can be retrieved easily from any part of the pool.