DC 5V 12V 24V Cycle Timer Switch, Programmable Power Timing Controller for Router Modem Auto Reboot No Case

1. Set System Time: Long press the SET button to enter system time setting. The hour digit flashes. Press the ADJ button to adjust the value. After setting the hour, press SET to configure minutes. Press ADJ to change the minute value. Once minutes are set, press SET to calibrate seconds; press ADJ to reset seconds to zero. Press SET to save and exit after calibration, or the settings will auto-save and exit after 10 seconds of inactivity. 2. Set Timing Points: Short press the SET button to enter timing point configuration. Red LEDs 1~6 indicate which timing point you are editing. Press the ADJ button to modify values. Press SET to switch to the next item after finishing one setting. The blue LED indicates the action to trigger at this time point: ON / OFF / Disable. Press the ACTION button to change the target action. Settings auto-save and exit after 10 seconds of inactivity. 3. Under normal working status, press the ADJ button to turn the display screen on/off (with power-off memory function). ADJ Button 4. Under normal working status, press the ACTION button to toggle the output state. ACTION Button Output: ON Output: OFF Color: As Shown Material: Plastic+Metal Specification: Without shell Package Contents: 1*Timer Switch Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.