DC Ammeter 100A 75mV Shunt Resistor for Accurate Current Conversion and Easy Panel Integration

DC100A(75mV) Shunt for Voltage Testers Product overview This DC100A(75mV) shunt converts DC current up to 100A into a proportional 75 millivolt signal for use with voltage testers and panel meters. It provides a simple interface for measuring currents with instruments that read low voltage inputs. Key benefits Accurate currenttovoltage conversion: delivers a stable 75mV output at 100A for straightforward measurement with compatible voltage testers. Protects measuring instruments: measures current indirectly via low voltage across the shunt, avoiding direct current through the meter. Easy integration: designed to work with voltage testers and panel meters that accept a 75mV shunt input. Compact and installable: sized for typical control panels and test benches for convenient placement and wiring. Reliable connections: screw terminals provide a secure electrical connection for conductors used in DC systems. Function and compatibility Function: converts DC current into a proportional low voltage signal to allow voltagemode instruments to display current values. Compatibility: intended for use with voltage testers, panel meters, and data acquisition devices that support a 75mV shunt input and DC current measurement up to 100A. Size model: DC100A(75mV). Performance notes Output characteristic: 75 millivolts at the rated 100 amps, enabling linear measurement over the device range. Suitable for continuous DC measurement up to the rated current when installed according to the tester or meter manufacturer recommendations. Typical applications Solar and battery systems: monitor charge and discharge currents of battery banks and inverter input or output currents up to 100A. Automotive and marine diagnostics: measure alternator, starter, and accessory currents where a 75mV shunt input is required. Bench and workshop testing: integrate with panel meters or multimeter voltage inputs to measure DC motor or power supply currents during development and troubleshooting. What is included and installation tip Model identification: DC100A(75mV) shunt for voltage testers. Installation tip: connect the shunt in series with the load and measure the voltage across the shunt output terminals with a compatible voltage tester or meter configured for a 75mV shunt input. This product provides a straightforward way to measure DC currents up to 100A by converting current to a low, measurable voltage compatible with common voltage testers and panel meters.