Features Non-isolated DC Regulated Voltage: This is a non-isolated DC regulated power converter module with long service life and selected electronic components. Wide Application: The drive power module is widely used in solar regulated charging, battery pack charging, high-power LED driving, etc. High Power and Stable Output: The automatic buck-boost power module has high power and stable output, the power module can convert 10-32VDC to 12-60VDC. High Conversion Efficiency: To a large extent, the constant voltage and constant current adjustable power module can ensure high conversion efficiency, up to 95%. Support Multiple Protections: The step up converter supports over-current, short-circuit, and over-temperature protections, with good heat dissipation performance, reliability and high precision. Specification: Type: Non-isolated step up module (BOOST) Input Voltage: 10~32VDC Input Current: 16A (MAX.); if more than 8A, please enhance heat dissipation Quiescent Current: 15mA(tested when converting 12V  to 20V; it will increase when output voltage is higher) Output Voltage: 10~60VDC continuously adjustable (Applies only to where the input voltage is less than the output voltage, can not step down voltage) Output Current: 8A (related to the input and output voltage difference, the greater voltage difference is, the smaller output current will be. please enhance heat dissipation when current is over 4A) Constant Current Output Range: 0.3~8A Turn Lights Adjusting Range: 0.3~8A Output Power: Natural cooling 90WMAX; Enhanced cooling 150WMAX Operating Temperature: -40℃ to 85℃(if temperature is too high, please enhance heat dissipation) Frequency: 150KHz Conversion Efficiency: 95% (Efficiency is related to input/output voltage, current and voltage difference) Short Circuit Protection: Yes (input 15A fuse) Reverse Input Protection: No, usually can connect diode in series to the input Output Indicator Light: With charging indication; it shows red when charging, green when fully charged Output Flow Back Protection: Yes Installation Method: Four 3mm screws (NOT included) Wiring Method: Terminal blocks Weight: 74g / 2.6oz (approx.) Package list: 1 * Voltage Converter Current Adjustment: 1, Adjust the CV potentiometer, depending on the load requirements, adjust the output voltage to the appropriate value, example:4 series of battery to 55V, 10 series LED to 37V 2, The module output current value is set to minimum (rotate counterclockwise CC potentiometer till you hear small crack sound from the potentiometer) Package List