Third, the structural composition:1. The hand-held electric scraper is composed of an electronic stepless regulator and a single-phase series motor and a scraping blade. It adopts a light and durable micro-drag switch and a spinning carbon brush. It has the characteristics of fast painting speed, high efficiency, simple operation, simple installation and stable quality, low failure rate, high production efficiency and novel design. 2. The fixed electric squeegee consists of two parts: electric power components (single-phase and series-excited motor) and scraping knives and governors.Fourth, the operation : 1. Insert the enamelled wire head to be painted into the center of the tool holder, press the power start switch (handheld) or the foot speed governor (fixed type), and the motor will rotate. 2. Move the enameled wire in the opposite direction of the axial direction until of the enameled wire, then the film can be scraped off. 3. Release the power button switch (handheld) or relax the governor (fixed). 4. Replace the work and repeat the above steps. V. Wire diameter adjustment and related matters:1. When the enameled wire is of different , the adjustable speed potentiometer (handheld) or the adjustable speed governor (fixed type) can be adjusted. The wire diameter is small in the slow direction, and the wire diameter is adjusted in the fast direction. If the film is not peeled off, the rotation speed is increased until it is scraped. If the enameled wire is cut by a scraper during speed regulation, the speed should be reduced until it meets the requirements. According to the above , the most suitable rotation speed is as the working speed of the corresponding wire diameter, which can be considered to have been adjusted. 2. When scraping the paint to of the enameled wire, do not immediately disengage the three blades. The intersection of the should wait for the tool to stop rot and then disengage, so as not to rotate, the enameled wire suddenly breaks off the and damages the . 3. The outer casing is made of voltage-resistant plastic material, which is safe and reliable. 4, before the enameled wire scraping paint, you must manually straighten the hand, to avoid the enameled wire is not allowed to the center of the . 5. After using for a long time, under the condition that the power supply is , the safety cover can be unscrewed to remove the peeled paint film powder. Color: dark green Material: ABS + electronic components Product size: 24*5cm Voltage: AC220V Package Contents: 1* English manual 1*Electric paint scraper Plug Type :EU Plug,it applies to Indonesia, Germany, France, Spain, Italy and so on. Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.