ECOSTAR RSC2 RSE2 Remote Control 433MHz Rolling Code Hormann Ecostar Liftronic 500 700 800 Garage Door Command Opener<br> Shipped within 24 hours (except holidays)<br> <br> 1. Type of programming: Programming with the receiver<br> 2. Number of channels: 4 / 2<br> 3. Code: rolling code<br> 4. Frequency: 433.92MHz 433MHz<br> 5. Battery:CR2032<br> Uses: garage doors, motorcycles, car alarm products, home security products, short-range wireless remote control products, industrial control products<br> Compatible Model:<br> ECOSTAR RSC2<br> ECOSTAR RSE2<br> Include<br> Remote Control<br> Battery<br> Clip<br> English Manual<br> How to Program<br> You have to press a button on the receiver (under the motor cover or next to the motor in a separate box), and then press a button on the new remote to register it. <br> Materials required for programming: your receiver!<br> 1. Open your receiver from the garage door.<br> 2. Press the programming button. Inscription is usually: ENR, MEMO or PROG.<br> 3. On some receivers, it is necessary to hold down the programming button.<br> 4. On the receiver the LED indicates the start of the programming mode.<br> 5. Press for one second on a button on the new remote control and let it go again.<br> 6. The LED of the receiver will light differently or goes out to indicate a successful programming.<br> 7. Wait a few seconds to exit the programming mode. <br> Congratulations! Your new remote control is programmed!