1The Engine Interface Module is a sealed, engine mounted module that provides switching relays for the starter motor solenoid, glow plug and fuel solenoid. Each of these circuits is protected with individual fuses mounted in the module. 2There are two versions of the Engine Interface Module available: EIM Basic: The ElM is utilised in conjunction with control panels equipped with overspeed shutdown. 3The ElM plus is used in conjunction with control panels not equipped with overspeed shutdown. 4If the engine speed rises above a certain pre-setable value, the module sends a 0 volt signal to the generator set control panel to activate the overspeed fault circuitry. 5The overspeed set point is factory set at 55 Hz for 50 Hz sets and 66 Hz for 60 Hz sets. This can be adjusted by using the adjustment screw accessed through the hole beside the overspeed set-up LED.Item Type:Engine interface moduleNumber: 630-466 Model: EIM PLUS Type: 859767 Serial Number: 38160008 Voltage: 24V DC Adopt original imported diodes, materials are flame retardant and high temperature resistant1 xEngine Interface ModulePlease note that the color next to the display light will be shipped randomly.