ESP RFID Tool RFID Smart Card Reader & Writer ESP RFID Reader simple

A tool compatible with logging Wiegand data and also compatible with testing devices contain a Wiegand Interface.A universal data logger that captures the raw binary data from a standard 5V Wiegand Interface. The device is capable of logging the credentials compatible with access control systems or nearly any device that utilizes a Wiegand Interface such as RFID card readers. pin pads. magnetic strip systems. and even some biometric readers.Wiegand Interfaces also do not have to be limited to just access control systems. The main target group compatible with this device is 26-37bit HID cards.compatible with known card types both the binary and hexidecimal data is displayed directly in the log file compatible with easy badge identification and also in case a clone of a card may be needed. compatible with unknown card types only the raw binary data is shown.NOTE:1.Wiegand RFID reader is not included.2.Don't power the module with battery only. Most of battery can't provide enough current compatible with WiFi connection. Please try to use 5V or 9V power adapter instead.The ESP-RFID-Tool also contains an unsupported experimental TX mode as well. In this mode you can transmit the raw binary of a card or even percompatible withm a couple of fuzzing tests. These include alternating bits on the D0 and D1 line and the device also has the ability to send bits on the D0 and D1 line at the same time. Although please note that the device has an output of 3V3 volts so it is not guaranteed to properly trigger all 5V Wiegand controllers. This mode is unsupported and was used compatible with debugging the software while it was being written. TX mode is only being included as a bonus feature. If you decide to use TX mode then do so at your own risk.Colour:GreenMaterial:PCB+ComponentsPackage contents:1 x RFID readerOnly the above package content. other products are not included.Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.