For Flipper Zero Wi-Fi Dev board Wi-Fi development board replica Only a few component packages have been changed, fully compatible with the firmware and all documents By default, the blackmagic firmware is flashed, and the 18 pins connected to For Flipper Zero are soldered, and the remaining pins are not soldered. For Flipper Zero ESP8266 Deauther Module Support WiFi Scanner firmware and deauther v2 firmware This module is only used by deauther and wifi scanner. To burn the firmware, use the uart function of For flipper zero or use the uart interface welded on the board with the usb to uart tool. For Flipper Zero ESP8266 WiFi Module Development Board Support WiFi Scanner firmware and deauther v2 firmware It can be plugged into For Flipper Zero and used with Deauther firmware. It can also be used as an esp8266 development board alone. The Type-C interface and serial port chip use ch340c, and an automatic burning circuit is added. Type-C can be connected to a computer to directly burn firmware. All IO ports are led out, and it is fully compatible with NodeMCU. Colour:green Material:PC+Metal type:C Package Contents: 1 x Module Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.