1. 6 Layer 2oz Thickened Copper Skin: PCB adopts high end 6 layer 2oz thickened copper skin, which makes overcurrent ability stronger and heat dissipation effect better. 2. 30V MOS: Using 30V MOS with high current resistance, long service life and strong load capacity. Industrial grade LDO, high temperature resistant. 3. Wide Range of Application: in current sensor, with wide range of Application, fit for FPV traverser, remote control aircraft and so on. 4. Diverse Features: in current sensor, F722D control firmware version, 2S‑6S input voltage, 40A continuous current, 50A current. 5. Simple Operation: Simple to operate, easy to install and disassemble. With wiring, protocol supports PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600. Item Type: F722 Controller Kit Control Size: Approx.32 x 32mm / 1.3 x 1.3in Mounting Hole Spacing: 25.5-26.5mm / 1.00-1.04in CPU: STM32F722RET6 IMU:ICM42688 OSD: AT7456E Barometer: Integrated BEC: 5V 3A LED: Support WS2812 And So On Sensor: In Current Sensor Control Firmware Version: F722D Receiver: For , For Futaba, For , For Crossfire, For , For DSM2 Receiver Firmware Support: BLHELI_ S Protocol Support: Support For PWM, For Oneshot125, For Oneshot42, Formultishot, For Dshot150, For Dshot300, For Dshot600 Input Voltage: 2S-6S Continuous Current: 40A Current: 50A Firmware Version: BLHELI _S (G- H-30) Application: Fit For FPV Traverser, Remote Control Aircraft, Etc Colour:red Material:plastic Package Contents: 1 x Flight Control Only the above package content, other products are not included. Note: Light reflection and different displays may the color of the item in the a little different from the real thing. The measurement allowed error is +/- 1-3cm.