HDMI-Compatible Cable Tester Data Wire Checker for HDMI-Compatible Pin Type Standard/Mini/Micro HDMI-Compatible Cable

1)Turn to the right to start the battery(CR2032 battery not included) 2)Turn to the left to connect USB-C 3)Turn to the left to connect Mirco USB 2. Measure the Pinout of an HDMI-Compatible Cable 1)Insert the Connector: Insert the HDMI-Compatible male connector into the B port of the test board. 2)Prepare the Multimeter: Set the multtimeter to the diode(countinuity)mode. 3)Test Each Wire: Touch the positive probe of the multtimeter to one of the HDMI-Compatible cable's copper wires.Touch the negative probe of the multtimeter to the shield of the test board. 4)Observe the Indicator Light: When the positive probe of the multtimeter touches a particular wire and the LED on the test board lights up,the number of the lit LED corresponds to the pin of number of that copper wire. 5)Record the Results: Based on the LED illumination,record the pin number for each copper wire.This will help you accurately determine the pinout for each copper wire. Important Notes: This HDMI-Compatible cable tester supports only Standard HDMI-Compatible Type A,Mini HDMI-Compatible Type C,and Micro HDMI-Compatible Type D.It does not support Type B or Type E interfaces. Color: Black & Transparent Material: PCB+Acrylic Package Contents: 1 x HDMI-Compatible Cable Tester Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.