Oscilloscope Multimeter Dual Channel Handheld Digital Oscilloscope AC100-240V Item Type: Oscilloscope Multimeter Material: ABS Model: HDS2102S Battery: 2 x Lithium Battery 2200mAh 3.7V(Built in) Usage: Electronic Signal Test Oscilloscope: Model: HDS2102S Bandwidth: 100MHz Channel: Dual Channel + Single Channel Signal Source Real Time Sampling Rate: 500MSa/s Sampling Mode: Normal, Peak Sampling Storage Depth: 8K Display: 3.5in LCD Waveform Refresh Rate: 10000wfrms/s Input Coupling: DC, AC, Ground Input Impedance: 1MΩ±2%, in parallel with 16pF±10pF Probe Attenuation Coefficient: 1X, 10X, 100X, 1000X Bandwidth Limit: 20MHz Time Base Range: 2ns/div-1000s/div, step by 1-2-5 Vertical Sensitivity: 10mV/div-10V/div Vertical Resolution: 8bit Low Frequency Response (-3db): <10Hz at BNC Rise Time (Typical on BNC): ≤3.5ns Trigger Type: Edge Trigger Trigger Mode: Automatic, Normal, Single Trigger Level: ±4 divisions from center of display Automatic Measurements: Frequency, Period, Amplitude, Maximum, Minimum, Mean, Peak to Peak Communication Interface: USB Type C Multimeter Part: Digital Display: 4 1/2 digits (maximum display 20000) Input Impedance: 10MΩ Diode: 0-2V 200.00mV 2.0000V/20.000V/200.00V 1000.0V 200.00mV/2.0000V/20.000V/200.00V 750.00V DC Current: 200.00mA 10.000A AC Current: 200.00mA 10.000A Resistance(Ω): 200.00Ω/2.0000kΩ/20.000kΩ/200.00kΩ/2.0000ΜΩ 20.000MΩ 100.00MΩ Capacitance(F): 20.000nF/200.00nF/2.0000μF/20.000μF/200.00μF/2.0000mF Frequency Response(Hz): (40 - 1000) Hz Signal Source Part: Waveform Output Frequency: Sine Wave: 0.1Hz-25MHz Square Wave: 0.1Hz-5MHz Ramp: 0.1Hz-1MHz Pulse Wave: 0.1Hz-5MHz Arbitrary Wave: 0.1Hz-5MHz Sampling Rate: 125MS/s Number of Channels: 1 Output Amplitude: 20mVpp-5Vpp (high impedance), 10mVpp-2.5Vpp (50Ω) Waveform Length: 8k Vertical Resolution: 14bits Output Impedance: 50Ω