[Easy belt lift] - The design provides a large gap between teeth on the wheel to lift the belt with your fingers, even when wearing gloves. - Belt width loading: the total belt width should not exceed 1.5 inches. Belts labeled 1 and 3 share the same dimension, below 1.6 inches. [Coil with 2 cores] - Spool supports cores with diameters 1 and 3; switching is simple by hand. - The holder fits 2 x 3/4 normal belts with 1 and 4 x 3/8 heating belts with 3. - The cutting belt length is consistent; you can also select the length to be captured. [Cut multiple belts at once] - Rotating windmill design activates the outer concealed cutting blade to cut to any required length. - To adjust length, rotate one side of the heating belt dispenser clockwise. Use scenarios - Quick changeover on production lines that use both standard belts and heating belts; set and cut to exact lengths on demand. - Repair or service shops that need to batch-cut multiple belts to the same length for stock. - Prototyping or testing labs requiring easy switching between belt types and precise length control.