ECOSTAR Garage door remote control 1. Type of programming: Programming with the receiver 2. Number of Buttons: 2/4 3. Code: Rolling code 4. Frequency: 433.92MHz 5. Battery: CR2032 With battery Uses: garage doors, motorcycles, car alarm products, home security products, short-range wireless remote control products, industrial control products 100% Compatible Model: ECOSTAR RSC2 ECOSTAR RSE2 Hermann Prolift Include: * Remote Control * Battery * English Manual How to Program You have to press a button on the receiver (under the motor cover or next to the motor in a separate box), and then press a button on the new remote to register it. Materials required for programming: your receiver! 1. Open your receiver from the garage door. 2. Press the programming button. Inscription is usually: ENR, MEMO or PROG. 3. On some receivers, it is necessary to hold down the programming button. 4. On the receiver the LED indicates the start of the programming mode. 5. Press for one second on a button on the new remote control and let it go again. 6. The LED of the receiver will light differently or goes out to indicate a successful programming. 7. Wait a few seconds to exit the programming mode. Congratulations! Your new remote control is programmed!