Item Type: DIY Mini Incubator <br>Material: ABS+Aluminum <br>Rated Power: 80W <br>Motor Voltage: 12V <br>Motor Power: Maximum 4W <br>Motor Working Mode: Forward/Reverse <br>Egg Turning Frequency: Every 2h/Time <br>Temperature Control Range: 37-39℃ <br>Scope of Application: 48 Pieces/56 Pieces/96 Pieces/112 Pieces<br>1、We provide you with a complete set of incubation accessories, you only need to prepare a box. <br>2、When the dual power cord is powered off, it can be connected to a 12V battery for safe incubation <br>3、Exhaust fan makes heat dissipation uniform, low noise, long use time, chip panel, one?key incubation control. <br>4、The home incubator motor has two working modes: forward rotation and reverse rotation. <br>5、Heating film, constant temperature PTC heating, the incubation temperature is guaranteed. 6、Humidity probe, digital probe, stable performance, accurate temperature sensor, accurate collection of information.1. The incubator needs to be prepared by yourself, which can be made of wood, acrylic, plastic, or glass. <br>2. The temperature of the heating plate can up to 270℃. Please use a gasket to isolate it when connecting and installing <br>3. In the design of the box, it is recommended to make a "sink" in the box to facilitate the addition of water, and the corresponding amount of water can be added according to the required humidity, so that the humidity of each area is within the normal range <br>4. Turning over the egg tray needs another shot <br>Installation instructions: <br>1, find a box, as an incubator carrier <br>Tips: in the process of designing the size of boxes, the size is generally ≥ 50 × 50 × 35cm(boxes are not limited to these two types, here is an example) <br>2, need to punch holes in the box, install accessories <br>Intimate tip: Screw hole position, please take the actual type as the standard (because the panel needs to be connected to the power supply, for safety, please add an inner box) <br>3. The box body is thoroughly drilled for air circulation1 x Panel<p>1 x Motor</p><p>1 x Exhaust Fan</p><p>1 x Heating Film</p><p>1 x Humidity Probe</p><p>1 x Temperature Probe</p><p>1 x Motor Link Line</p><p>1 x Plug</p><p>1 x 12V Power Cable</p><p>1 x Manual</p><p>12 x Screw</p><p>8 x Nut</p><p>8 x Gasket</p><p>8 x Insulation Column</p>