ICM-20689 Module / High-Performance 6-Axis MEMS Motion Tracking / Accelerometer / Gyroscope / Motion Processing

1.The ICM-20689 is a 6-axis motion tracking device that combines a 3-axis gyroscope, a 3-axis accelerometer, and a Digital Motion Processor (DMP) in a small 4x4x0.9mm (24-pin QFN) package.<br> 2.A large 4K-byte FIFO reduces traffic on the serial bus interface and reduces power consumption by allowing the system processor to burst read sensor data and then enter a low-power mode.<br> 3.Gyroscope with programmable FSR of ±250°/s, ±500°/s, ±1000°/s, and ±2000°/s.<br> 4.Accelerometer with programmable FSR of ±2g, ±4g, ±8g, and ±16g.<br> 5.EIS FSYNC support.<br> The ICM-20689 includes an on-chip 16-bit ADC, a programmable digital filter, an embedded temperature sensor, and programmable interrupts. The device has an operating voltage range as low as 1.71V. Communication ports include 2C and 8MHz high-speed SPI.<br> User-programmable interrupts<br> Motion wake-up interrupts for low-power operation of the application processor<br> 4K-byte FIFO buffer enables the application processor to read data in batches<br> On-chip 16-bit ADC and programmable filter<br> Host interface: 8MHz SPI or 400kHz Fast Mode 2C<br> Digital output temperature sensor<br> VDD operating range of 1.71V to 3.45V<br> MEMS structure sealed and bonded at the wafer level<br> Applications:<br> Mobile phones and tablets<br> Drones<br> Motion-based game controllers<br> 3D remote controls and 3D mice for internet-connected DTVs and set-top boxes<br> Wearable sensors for health, fitness, and sports<br> Functional This module reads data via the I2C interface. The I2C device address is 7 bits long, with the last bit of the 7-bit address determined by the level of the ADO pin. ADO is pulled down to ground by default. Data from the 3-axis gyroscope and 3-axis accelerometer can be read via I2C.<br> Color: Black<br> Material: plastic<br> Package Contents:<br> 1 x ICM-20689 Module<br> Only the above package content, other products are not included.<br> Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measure