* New and high quality * Made of high-quality materials, * JR1810RX 6-12V children's electric vehicle control box ZCY1810RX receiver 5 pins and 7 pins * Connect the remote control and receiver * Remote control receiver controller for children's electric vehicles. * Press and hold the forward and back buttons at the same time, the indicator light flashes, and then turn on the car. The indicator light stops flashing and the connection is successful. * Various styles, better choices. * First use (or battery replacement) requires a matching frequency. * Step 1. Install two AAA 1.5V batteries (note the positive and negative polarities in the battery compartment), and finally close the battery cover, and the indicator light will flash 3 times, indicating that the battery is installed correctly. * Step 2. Press and hold the frequency key (car selection) for about 2 seconds, and the indicator light will flash. * Step 3. Turn on car and the light went out. * Step 4. If the matching frequency is unsuccessful (the indicator light does not turn off), turn off the power and repeat steps 2 and 3. Specifications: Type: Baby car accessories Color: As shown in the figure Model (optional): Remote control, ZCY1810RX 5pin, 5 pin Full set, ZCY1810RX 7pin, 7 pin Full set Package Included Listing 1:1 x remote control Listing 2:1 x receiver Listing 3:1 x remote control + 1 x receiver Note: 1.The real color of the item may be slightly different from the pictures shown on website caused by many factors such as brightness of your monitor and light brightness. 2.Please allow slight manual measurement deviation for the data.