FITS FOR ALL 10MM 5050 4 Pin RGB STRIPS: This LED light connectors kit fits for all 10mm wide SMD 5050 RGB LED light strips and the connectors are all 4 pin style. This is very important so please make sure of it before purchase. And please peel off silicon on the surface around soldering area when connecting the waterproof SMD RGB 5050 waterproof light strips EASY INSTALLATION & NO SOLDERING: You don't need solder any components while using this connectors set. It's very easy to use, open the wire clip, insert your 10mm light strip into the gapless connector and confirm positive "+" corresponds to negative "+"correctly, then close the clip and pull on the wire to confirm you've secured the strip inside the connector. You can easily use the kit to connect between strip to strip, strip to controller, strip to splitter CUSTOMIZE YOUR LED STRIP LIGHTS: The perfect set of connectors to set up your easily and make them custom. You can use waterproof-design easy-clasp solderless connectors to connect different LED strips, also using L type or T type connectors to connect the corners of , table corners, wall or ceiling etc. perfect for Kitchen, makeup mirror, dining table, cabinets, cove, pelmet, shelf or wardrobe lighting or in commercial applications Colour:white Material:plastic Package Contents: 1 * 2 RGB splitter cable 8 * LED strips with 2 * 4 pin female connector with bare wire terminals 20 * 4 pin male to male connector 12 * L-shaped connectors 2 * T shaped connector 20 * clamp screws 10 * without a space connectors 10 * adhesive connector 2 * 1 * screwdriver Only the above package content, other products are not included. Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.