The M.2 SSD enclosure is specially designed for M Key & M+B Key NVMe PCle SSD, compatible with 2230/2242/2260/2280/22110 full-size M.2 NVME solid-state drives, supporting up to 2TB hard drives. SSD Enclosure Docking Station with JMS583 controller chip ensures strong compatibility and stability while supporting UASP acceleration protocol to protect data security. The USB 3.1 Gen 2 interface offers faster read/write speeds up to 10Gbps. Supports offline cloning; the hard drive enclosure must not be connected to any device during cloning. Cloning is a one-to-one clone of the entire disk and does not intelligently identify data on the hard drive, so back up data on the target disk before cloning to avoid losing important data! M.2 NVMe enclosure allows for quick and easy installation of your M.2 NMVe SSDs. Plug and play, no driver needed. Simply slide the back cover and open the case, then plug your M Key or M+B key M.2 SSD into the slot. Made of high-quality aluminum alloy, it has better heat dissipation. The LED indicator lets you easily know the working status. M.2 NVMe SSD enclosure supports write protection. When the write protection switch is turned on, no files can be put into the hard drive to prevent the hard drive from being invaded by viruses; the content of files on the hard drive cannot be saved after being modified to prevent the content from being changed by mistake; no files on the hard drive can be deleted to prevent files from being hacked or deleted by mistake or intentionally. Model: M.2 NVME Protocol Support Capacity: M.2 Single Disk Supports 2TB Max Support Hard Drive: Supports M.2 NVME Protocol, 2230/2242/2260/2280/22110 and other sizes of solid-state drives Transmission Interface: Type-C Transmission Speed: 10Gbps Color: Gray Material: Aluminum Alloy Size: 4.4x1.1cm Package Contents: 1 * SSD Enclosure 1 * USB A to USB C Cable Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture to be slightly different from the real one. The allowed measurement error is +/- 1-3 cm.