MPPT Wind Charge Controller 12/24V 800W compatible with Wind Turbine Systems

1. Automatically charges the battery. 2. The rectifier and brake circuit of this controller uses an integrated module, offering improved heat dissipation and reliability compared to traditional designs. 3. Features a fully sealed, waterproof design with a protection rating of IP67, allowing compatible with long-term normal operation even when submerged in water. Note: Ensure the output voltage of the wind turbine generator matches the rated voltage of the battery. Connect the wires in the following order: first connect the battery’s positive and negative terminals, then connect the three-phase output from the wind turbine. Connect the battery and wind turbine to the controller according to the instructions. Reversing polarity or incorrect connections may cause system malfunction or permanent damage to the controller. Wiring instructions: 1. Connect the battery’s positive and negative terminals to the corresponding positive (red) and negative (black) terminals on the controller. 2. Connect the three-phase output wires from the wind turbine to the three-phase input (green wires) on the controller. Specifications: 1. Maximum input AC voltage: AC35V 2. Output voltage: 12V / 24V 3. Battery charging cut-off voltage: 14.5V ± 0.3V / 29V ± 0.3V 4. Maximum charging current: 15A (12V), 10A (24V) 5. Wind generator speed limit voltage: 14.5V ± 0.3V / 29V ± 0.3V 6. Protection level: IP67 7. Static power consumption: 0.008A 8. Maximum load power: 800W 9. Maximum allowable wind speed: 12 m/s 10. Operating temperature: -35°C to 65°C 11. Input wiring: Three-wire system 12. Control mode: Compatible with 12V/24V systems 13. Installation: Bolted 14. Do not reverse the positive and negative terminals to prevent damage to the controller. Application: Wind generator controller Color: Blue Material: Aluminum alloy Package Contents: 1 x MPPT Wind Generator Controller Note: The package includes only the items listed above. Light reflection and display differences may cause slight variations between the product color in images and the actual color. Measurement error allowed: +/- 1-3 cm.