["Features:\nMade of high quality ABS and metal material, it is solid, durable and good performances, serve you for a long-term.\n0.5-6L/minutes, high efficiency, stable performances.\nG 1/4\" fast connection interfaces, easy to install.\nSuitable for water dispenser, water heater and so on.\nWater flows sensor only, other accessories demoed in the picture is not included!\n\nSpecification:\nMaterial: ABS, Metal\nOutput voltage: DC5V\nInterfaces: G 1/4\" \nLength: approx.3.5x2.8x5.4cm/1.38x1.10x2.13in\nColor: White\nQuantity: 1Pc\n\nProduct Parameters:\nStart water flows: Less than 0.20L/minutes\nStarting water pressure: Less than 0.1Mpa\nWorking flows range: 0.5-6L/minutes\nPay attention to clean the air impellers on the residual water when the output signal is not highers than 150HZ, idle for time should be 30 seconds.\nBearing water pressure: up to 0.8Mpa\nOperating voltage range: 3.5-12VDC\nOperating current: 0.51.5MA\nWorking environment temperature: 1-100\nApplicable environment temperature: –40-100\nOutput characteristic: (32xQ)Q for traffic L/minutes, Hz (Hz); Error ±3%\nService life: 106H\nElectrical strength: Over 600VAC, Durations of 5S leakage current 3mA\nInsulation resistance: Over 100mΩ, The insulation resistance between the connector and the housing body or the valves body.\n\nNote: \nNo retail package.\nPlease allow 0-1cm error due to manual measurement. please make sure you do not mind before you bid.\nDue to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!\n\nPackage includes:\n1x Water Meter Flows Sensor"]