Works with specific standard 90-degree jacks (CAT5, CAT6, and CAT6a shielded). Simply seat all 8 wires into a 90-degree punch-down type jack, then insert the jack into the tool. One-handed operation allows you to punch down and trim all 4 pairs of your Ethernet cable into a 90-degree jack with a single crimp. This saves time and effort by enabling simultaneous wire termination with a quick squeeze of the tool. Ergonomically designed handle for comfortable use. Seats and cuts all wires at the same time, reducing hand fatigue. The tool also trims excess wire, ensuring a clean and precise termination every time. Significantly increases termination speed and accuracy. Helps keep your RJ45 jack neat and organized during network cable installation. Reduces the risk of damaging the jack or Ethernet cable. Color: Green Material: Metal Package Contents: 1 x 90-Degree Termination Tool Note: The package includes only the items listed above. Other products are not included. Note: Lighting and display differences may cause slight variations in the color of the item as shown. Measurement may vary by +/- 1-3 cm.