In-Circuit programming target chip Online/offline programming mode Backup flash data of target chip (if the target chip is not flash protected) Backup offline flash data of Nu-Link dongle (if offline data has been unprotected) Write software serial number (SN) to target chip Limit the maximum programming count Data encryption for online/offline programming Batch mode for online/offline programming Preparing for ICP Programming Tool System Requirements: PC/AT compatible machine with Pentium or higher CPU XGA (1024x768) color monitor At least 512 MB RAM for best performance At least 20 MB free disk space Windows 2000/XP/Vista/7 Hardware Installation: Step 1: Plug USB cable into the USB port of the ICP Programming Tool board. Step 2: Connect the ICP Programming Tool board with ICE interface of DEV board. Software Installation: Run the installer package to install the software. Appearance may vary by batch; this does not affect functionality. Color: As shown Material: Plastic Package Contents: 1 × NuMicro ICP Programmer Kit