Auto detection of K-Line/CAN, with option to bypass and force preferred communication protocol. Temporary immobilizer bypass to allow bench flashing on ME7 systems. Boot mode support for ECUs with C167 and ST10 processors. EEprom read/write functions available for select ECUs. TPROT level checking for MEDC17 without opening the ECU. Installation instructions: Use Windows 7 system. Install driver from included CD before running software; do not use drivers intended for other MPPS versions. This module enables advanced functions on various ECUs. Supported controllers include M3.8, M5.9, ME7xx, MED9, MED17, EDC15/16/17, Delco, Trionic, and others. Compatibility: - 6JF: Full Read/Write microcontroller and EEprom via K-line - 8DF: Full Read/Write microcontroller and EEprom via K-line - 8F2: Full Read/Write microcontroller and EEprom via K-line and CAN - 8F3: Full Read/Write microcontroller and EEprom via K-line and CAN - 8GM: Full Read/Write microcontroller and EEprom via CAN - 8GS: Full Read/Write microcontroller and EEprom via CAN - 5SF3: Full Read/Write Flash and EEprom via CAN - 5SF3: Full Read/Write EEprom via K-line - 5SF8: Full Read/Write Flash and EEprom via K-line and CAN - 5SF9: Full Read/Write Flash and EEprom via CAN Material: ABS plastic Color: Black Package Contents: 1 x MPPS V18.12.3.8 1 x Breakout Tricore Cable 1 x Connection Cable 1 x CD Note: Light reflection and display differences may cause slight variation in color appearance. Measurement error allowance: +/- 1-3 cm.