Feature:1. Support acid battery and working battery, voltage range: 6V - 60V;2. It can display voltage, battery percentage, charging time at the same time by LCD3. The function is very powerful, realizes automatic charging control, control charging time, can also configure and transmit the corresponding parameter through the serial portSpecifications:Product Model: XY-L10A Control Voltage: DC6-60V Control Line:lt; 10A Control Accuracy: 0.1V Output Type: Direct Output Voltage Error: 0.1V Application Range: Various Lithium Batteries. Feature Description1. Automatic Charge Control Function: By setting volt-hi: "up" volt-li: "dn"; When the battery voltage is below volt-li: "dn", the relay guides, the charger starts to charge the battery; When the battery voltage is to Volt-Hi: "Up", the relay is DIED and automatic charging is completed once2. Load time control feature:How to enable the time control feature? After entering the parameter set, set the parameter op is not zero, and then enable the time control function, the default parameter op is:-:-h, does not enable the time control function by default; After opening the time control function (OP is non-zero), when the battery voltage is lower volt-li'dn", the charger started to charge the battery, the system started to clock; When timing, the battery voltage ge; volt-hi'up', disconnecting the relay; If the OP time is higher, , the battery voltage is still lower volt-LI'dn', the relay maintains conduction, closes the automatic charging function time control, and flashes H:ER to remind the user, the time parameter setting is unreasonable; Press any key to stop flashing; Note: Time format: 00:59 (00 for hours, 59 for minutes) the maximum time is 99:59, which is 100 hours.. Parameter settingA) press and hold the SET button to enter the setting interface; B) switch the parameters you want to set by short pressing set; C) after selecting the parameters, can be set by the up/down key to support short press, long press (quick increase or decrease); To set other parameters, repeat step b, c); D) after all parameters are set, press and hold the set button to exit and save; . Key Function Description:In the Run interface (main interface):Short press the SET button to display the current set of parameters; Short press with binding, button-fastened, switch the display percentage and charging time; Short press down button, select relay on/off power on, if the relay can be closed, it will show "off" as a reminder; Long press with binding, button-fastened, low power switchOn: no operation within 10 minutes turn off the backlightOFF: the backlight is always brightLong press the SET button, make the parameter settings.. Voltage Percentage Calculation: Voltage Percentage = Battery Voltage/(volt-hi-volt-li), Additional FunctionsA) Charging Time Recording Function: Not open charging time control, the product will record full-time when the input time display interface, the display charging time flashing, and then exit the time display interface or the next charge to open (relay conduction) when empty; B) automatic parameter detection: after setting the parameters, exit if volt-li dnge; volt-hi UP, the system will display "ERR" as a reminder; C) Battery Access Detection: This product is connected to the battery, if it is not connected to the battery, the system will be shown in the "NbE" link as a reminderSize: 7.9x4.2cm/3.11x1.65inchNote: Please allow 1-3mm error due to manual measurement. pls make sure you don't mind before you bid. Due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!Package Included:1x Battery Charger Control Module