Note:the kit no including the printparts Based on two : the Klicky Probe by JosAr and the Probe This design attempts to replicate Klicky as closely as possible using a PCB-based design, to try and achieve the following : 1.Reduce the problem of magnets working lose or seating poorly in printed parts 2.Increase the current being switched, which might possibly result in a longer switch . 3.Add LEDs. Material: PCB+Plastic+Metal colour: black Package Contents: 2 x toolhead PCB (pre-assembled with SMD components) 4 x probe PCBs 2 x JST-XH 3 pin header 2 x JST-XH 3-wire pigtail connector 10 pairs x countersunk magnets 20 x M2x3.2x4mm heatset inserts 20 x M2x8mm flat head screws 4 x carbon steel M3x6mm flat head screws Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.