Feature: 1. APPLICABLE MODEL: PEO PEI build plate is suitable for Kobra2 Maximum, for Neptune3 Maximum, for Neptune4 Maximum and other models, double sided texture, both sides can be printed, and the service life is twice as long as the single side 2. PEI SIDE: PEI powder spraying, matte texture appearance, prevent wear, not easy to scratch, can bring good adhesion to various printing materials, such as PLA, ABS, TPU, PETG, nylon, temperature prevention up to 260℃ 3. PEO SIDE: PEO is a glossy appearance, easy to stick model, the bottom of the printed model shows lines, exquisite and beautiful, easy to wash, can be well adhered to PLA, PETG and other materials, temperature prevention 120℃ 4. MAGNETIC BASE: Made of soft magnetic rubber, soft texture, and has good magnetic and temperature prevention, with back glue, can be directly affixed to the hot bed platform, long-term high temperature prevention of 130℃, far supermarket appearance temperature prevention of 70℃ products 5. GOOD PRINTING RESULTS: Your printed workpiece can be easily fixed to the print appearance, and the PEO PEI flexible sheet also makes disassembly very easy. The appearance adhesion is strong, no glue is needed, and the side is not warped, and the bottom appearance of the printed product is with frosted effect, very beautiful Specification: Item Type: PEO PEI Build Plate Material: PEI and PEO Size: Approx. 430x430mm / 16.93x16.93in. Package List: 1 x Print Bed 1 x Base Note: Attach the magnetic base to the build board by tearing off the backing paper, then align the board. PEI or PEO side up for easy printing. Remove the protective film from the appearance before printing.